• Re: ev tires.. diff sizes

    From Rob Mccart@1:2320/105 to KURT WEISKE on Wed Feb 4 07:49:42 2026
    I have a 1993 Dodge Dakota pickup that has the same size tires all
    around, but calls for the fronts to be inflated to 5 PSI less than the rears. This is the first, and only, vehicle I have owned that did
    that.

    That makes sense - if you're loaded to the hilt, you'd need additional
    >tire pressure to help support the weight.

    That's a good point. I missed that, and I shouldn't have because,
    regardless of recommenations, when I had a Ford F150 with special
    suspension to carry over 2000 lbs, I often had my rear tires
    inflated as much as 10 lbs higher than the front.

    Speaking of which (maybe this should go to AUTOMOTIVE?) I read an
    >interesting article. I've had the past few sets of high-mileage tires wear
    >out on the outer edges. I thought it was alignment, then realized both inner
    >and outer edges were worn. I kept the tires at the recommended pressure.
    >Apparently the recommended pressure is intended for a fully-loaded vehicle.
    >Driving solo under-loads the tires. I started inflating them a couple of PAI
    >higher and got better life from the tires.


    Someone can correct me if I'm wrong but, it seems to me of your
    tires are carrying less load than the tire pressure is set for,
    the wear should be in the middle, not the outer edges, since the
    weight isn't there to flatten the tire right down to the road
    surface.. (?)

    ---
    * SLMR Rob * Honest, Officer! Barney was on fire when I got here!
    * Origin: Capitol City Online (1:2320/105)
  • From Kurt Weiske@1:218/700 to Rob Mccart on Wed Feb 4 15:13:37 2026
    Rob Mccart wrote to KURT WEISKE <=-

    Someone can correct me if I'm wrong but, it seems to me of your
    tires are carrying less load than the tire pressure is set for,
    the wear should be in the middle, not the outer edges, since the
    weight isn't there to flatten the tire right down to the road
    surface.. (?)

    Now I'm confused!


    ... "Unlocking Paradigms, one blockchain at a time..."
    --- MultiMail/DOS v0.52
    * Origin: http://realitycheckbbs.org | tomorrow's retro tech (1:218/700)
  • From Rob Mccart@1:2320/105 to KURT WEISKE on Fri Feb 6 08:21:33 2026
    Someone can correct me if I'm wrong but, it seems to me of your
    tires are carrying less load than the tire pressure is set for,
    the wear should be in the middle, not the outer edges, since the
    weight isn't there to flatten the tire right down to the road
    surface.. (?)

    Now I'm confused!

    Looking at it the opposite way is easier to picture..
    If you over-inflate the tires then they will bulge out and
    wear more in the middle and not at the outer edges..

    ---
    * SLMR Rob * The GOOD news is now my shrink gives me a group discount.
    * Origin: Capitol City Online (1:2320/105)